Carmanah SPEEDCHECK-12 설치 매뉴얼 - 페이지 10

{카테고리_이름} Carmanah SPEEDCHECK-12에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah SPEEDCHECK-12 14 페이지. Solar charge controller
Carmanah SPEEDCHECK-12에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 교체 매뉴얼 (10 페이지), 교체 매뉴얼 (12 페이지)

페이지 인쇄

9. Install AI FCU onto mounting plate with three #8-32x1/4" screws.

10. Install screw mount cable tie around harness wires end secure to lower-left mounting plate standoff with

one #8-32x3/8" screw.

11. Install harness ground ring terminal onto stud shown and fasten with one nyloc nut. Orient as shown.

12. Thread GPS and LTE antenna coax harness connectors onto correct connectors on the AI FCU (not

shown below).

Yellow sensor wire will remain unterminated for AC-powered systems. For solar-powered

systems this will mate with the yellow wire from the solar kit. See

information.

13. Connect the 2-pin and 4-pin AI FCU connectors to the open receptacles on the display enclosure as

shown below. All 2-pin connectors are interchangeable.

Battery Only or AC w/ AI FCU

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

APPLIED INFORMATION (AI) INTEGRATION

Section 4.3

Solar Kit w/ Battery & AI FCU

[email protected]

INSTALL GUIDE

Cell – Front

GPS – Rear

for more

carmanah.com