ANDELI MCT Series 소유자 매뉴얼 - 페이지 10
{카테고리_이름} ANDELI MCT Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANDELI MCT Series 20 페이지. Multifuction welding&cutting machine
페이지 인쇄5.5.2MIG Welding Installation
By pressing function selection button on front panel
By pressing setting button
type;By pressing setting button (7)to select Aluminum welding,ALSI/ALM.Note,When having aluminum
welding, MIG torch should change to use the graphite guide wire tube,and wire feeder should change
to use
U-shaped roller.
By pressing setting button (8)to adjust inductance.
By pressing "Gas Check"
After finish the installation and setting, press the MIG torch switch to start welding working
By rotating the knob to adjust welding voltage.The larger the Welding voltage, the longer the arc,
the shallower the melting depth and the wider the melting width.
By pressing the encoder to switch and adjust the wire feeding speed. The larger the current is,
the faster the wire feeding speed will be. In this case, the gas flow can be adjusted appropriately.
Note: For details,please refer to Page6, the "Panel description".
gas cylinder
220V
(3)to select wire diameter;By pressing setting button (7)to select gas
button to check gas.
Connect the MIG Torch Euro Connector to the torch
socket on the front of the welder . Secure by firmly
hand tightening the threaded collar on the MIG
Torch Euro Connector clockwise.
Check that the correct gas shielded wire, matching
drive roller
and welding tip
Connect Polar conversion line
welding output terminal .
Connect Earth Lead Quick Connector to the
negative (-) output welding terminal .
Connect Earth Clamp to the work piece. Contact
with work-piece must be strong contact with clean,
bare metal, with no corrosion, paint or scale at the
contact point.
Connect gas cylinder to the MIG gas inlet.Turn on
the gas valve and adjust to the desired flow.
Connect to AC 220V input voltage,Turn on the
power switch to start
,To select 2T or 4T working mode.
9
are fitted.
to the positive (+)
the machine.