ANDELI MCT Series Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ANDELI MCT Series. ANDELI MCT Series 20 pagina's. Multifuction welding&cutting machine

Pagina afdrukken

5.5.2MIG Welding Installation

By pressing function selection button on front panel

By pressing setting button

type;By pressing setting button (7)to select Aluminum welding,ALSI/ALM.Note,When having aluminum

welding, MIG torch should change to use the graphite guide wire tube,and wire feeder should change

to use

U-shaped roller.

By pressing setting button (8)to adjust inductance.

By pressing "Gas Check"

After finish the installation and setting, press the MIG torch switch to start welding working

By rotating the knob to adjust welding voltage.The larger the Welding voltage, the longer the arc,

the shallower the melting depth and the wider the melting width.

By pressing the encoder to switch and adjust the wire feeding speed. The larger the current is,

the faster the wire feeding speed will be. In this case, the gas flow can be adjusted appropriately.

Note: For details,please refer to Page6, the "Panel description".



gas cylinder

220V



(3)to select wire diameter;By pressing setting button (7)to select gas

button to check gas.

Connect the MIG Torch Euro Connector to the torch

socket on the front of the welder . Secure by firmly

hand tightening the threaded collar on the MIG

Torch Euro Connector clockwise.

Check that the correct gas shielded wire, matching

drive roller

and welding tip

Connect Polar conversion line

welding output terminal .

Connect Earth Lead Quick Connector to the

negative (-) output welding terminal .

Connect Earth Clamp to the work piece. Contact

with work-piece must be strong contact with clean,

bare metal, with no corrosion, paint or scale at the

contact point.

Connect gas cylinder to the MIG gas inlet.Turn on

the gas valve and adjust to the desired flow.

Connect to AC 220V input voltage,Turn on the

power switch to start

,To select 2T or 4T working mode.

are fitted.

to the positive (+)

the machine.