Carmelli NG2325B 조립 지침 매뉴얼 - 페이지 4

{카테고리_이름} Carmelli NG2325B에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmelli NG2325B 14 페이지. Bounceback 9' table tennis
Carmelli NG2325B에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (10 페이지)

페이지 인쇄

ASSEMBLY INSTRUCTIONS

1. Unfold the outer (player end) pre-assembled leg to a straight upright position.

2. Attach the INNER (center end) LEG, #19, to the backside of the TABLE SURFACE, #1 and #2, with METAL

BRACKETS, #8, using SCREWS, #5, in pre-drilled holes. Note: The Metal Bracket's slot opening needs to point in the

same direction as the other leg assembly (toward center end) with both Leg Pins in slots.

3. Attach the LINKAGE TUBE, #6, and TUBE WITH STOP BRACKET, #14, to the legs with BOLTS, #10, WASHERS, #7,

BUSHINGS, #9, and NUTS, #12, as shown below. Note: The ends of the Linkage Tube and Tube with Stop Bracket that

attach to the outer (player end) pre-assembled leg are assembled on the inside of the legs. The other ends, that attach to

the inner (center end) leg are assembled on the outside of the legs. Also note, the position of the Stop Bracket.

IMPORTANT:

Note: Position of

Stop Bracket

Note: Slot position

Tip: The extra hole on the Inner Leg, #19, is used for

installing the safety locks in a later step. Position so

locks will be on the same side when Table Surfaces

are flipped.

#14