ATI Technologies SR-61 교체 매뉴얼 - 페이지 10

{카테고리_이름} ATI Technologies SR-61에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Technologies SR-61 11 페이지. Robotic collision sensor switch replacement manual

페이지 인쇄

Manual, Collision Sensor Switch Replacement,SR‑61

Document #9610‑60‑1014‑02

11. Push on the press handle until the switch circuit opens and check the distance traveled on the

dial indicator.

12. If the distance traveled is greater than desired turn the proximity switch counterclockwise. If the

distance traveled is less turn the proximity switch clockwise.

13. Repeat steps (11) and (12) as necessary to obtain the desired switch setting.

Dial

Indicator

Interface

Plate

Arbor

Press

14. Tighten the locknut on the proximity sensor.

15. Slide the connector block over the proximity sensor carefully routing the wires into the slotted

area under the proximity sensor. Line up the dowel pin with the hole in the body and the screw

hole with the threaded hole in the body.

16. Apply Loctite 222MS to the M3 mounting screw and thread it into the body. Tighten the

screw securely.

17. Re‑install the Collision Sensor using the user‑installed mounting hardware.

1.5.2 Current Style Switch Adjustment

Note: The switch is factory adjusted to open after the stem has traveled .020" in the axial direction.

Adjustments should only be made if replacing the switch.

1. De‑energize all electrical and pneumatic power supplied to the Collision Sensor. Drain all stored

air and electric power in compliance with standard (OSHA) safety practices and standards.

2. Disconnect the air lines and signal wires connected to the Collision Sensor.

Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: 919.772.0115 • Fax: 919.772.8259 • www.ati‑ia.com

Figure 1.7—Checking Switch Height Adjustment

CAUTION: Before putting the Collision Sensor back into operation, confirm that

the switch is functioning properly. See

Section 1.4.1—Test Switch

Arbor

Press Ram

Sensor

Lock Nut

Sensor

Functionality.