ATI Technologies QC-210 매뉴얼 - 페이지 13

{카테고리_이름} ATI Technologies QC-210에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Technologies QC-210 17 페이지. Tool changer

Manual, Robotic Tool Changer Third Generation Teaching Aids

Document #9610-20-3370-02

5.2 Service Procedures

The following procedures provide instructions for component replacement and adjustment.

Parts required: Refer to

Supplies required: Loctite

1. Using the appropriate Allen wrench, remove the fasteners from the Teaching Aid plate. Refer to

Figure

2. Remove the magnets that require replacement.

3. Place the new magnet(s) in the Teaching Aid plate.

4. Apply Loctite Primer 7649 and Loctite 262 to the fastener threads.

5. Insert the fasteners into the Teaching Aid plate. Using the appropriate Allen wrench, thread into

the magnet. Tighten to 12 in-lbs (0.8 Nm).

Socket Head

Cap Screw

Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: 919.772.0115 • Fax: 919.772.8259 •

Section 6—Serviceable Parts

Primer 7649 and Loctite 262, 3/32 (for 4-40 Socket Head Cap Screw),

torque wrench

5.1.

Figure 5.1—Adjustment or Installation of Magnets

Magnet

www.ati-ia.com

Teaching Aid

• Email: