Andersen 52ST 매뉴얼 - 페이지 3
{카테고리_이름} Andersen 52ST에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen 52ST 6 페이지.
Andersen 52ST에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)
페이지 인쇄
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the position numbers in
the parts list.
What's required for the installation?
Screwdriver (large).
Ø8.5 mm. drill.
Ring spanner to match nuts.
5 x M6x8 (1/4") countersunk head screws and corresponding nuts.
5 x large washers or backing plate ø6.
Bedding compound
1.
Remove screws (1).
2.
Remove self-tailing arm (2) and drum (5).
3.
Mark location of boltholes using the drilling template RD100516 or RD100213.
4.
Remove complete winch. Be sure that no dust comes into contact with the winch while drilling.
5.
Drill the bolt holes Ø8.5mm (11/32").
6.
Apply a light coat of bedding compound, ensuring that each bolthole is bedded.
Keep drain grooves clear.
7.
Fasten lower base (22) and cover (23) into place using 6 pcs. M8 (5/16") countersunk head screws. Use
large washers or a backing plate.
8.
Assemble in reverse order.
9.
Check that the winch is functioning correctly:
The drum should operate smoothly, by turning the drum clockwise by hand.
The drum must not turn when trying to turn the drum anti clockwise.
While turning the winch handle clockwise the drum should turn fast.
While turning the winch handle anti clockwise the drum should turn slowly.