Andersen 78FS 매뉴얼 - 페이지 3
{카테고리_이름} Andersen 78FS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen 78FS 7 페이지.
페이지 인쇄
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the position
numbers in the parts list.
Tools required for the installation:
Allen key (10 mm.).
Allen key (6 mm.).
Drill Ø12,5mm.
6 pcs. M12 countersunk head screws.
1.
Remove screws (20).
2.
Remove self-tailing arm (17) and drum (32).
3.
Mark location of bolt holes using the lower base (1) as a template.
4.
Remove complete winch. Be sure that no dust comes into contact with the winch while
drilling.
5.
Drill bolt holes ø12,5 mm.
6.
Apply a light coat of bedding compound, ensuring that each bolt hole is bedded. Keep
drain grooves clear.
7.
Fasten lower base (1) into place using 6 pcs. M12 countersunk head screws. Use large
washers or a backing plate.
8.
Assemble in reverse order.
9.
Check that the winch is functioning correctly:
The drum should operate smoothly, by turning the drum clockwise by hand.
The drum must not turn when trying to turn the drum anti clockwise.
While turning the winch handle clockwise the drum should turn slowly.
While turning the winch handle anti clockwise the drum should turn fast.