Andersen 82-3ST 제품 설명서 - 페이지 6
{카테고리_이름} Andersen 82-3ST에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen 82-3ST 12 페이지.
페이지 인쇄ANDERSEN Stainless Steel Winches
Your Andersen winch is made with the care and craftsmanship that come from more than sixty
years of experience. Andersen winches are built to last, to retain their exceptional finish and to
deliver season after season of reliable performance and sailing pleasure to their owners through
the years.
INSTALLATION
Required for installation:
•
Drilling/mounting templates for 82-3ST winch
•
Hex key, 5mm (included)
•
Hex key, 10mm for winch mounting bolts
•
Drill bit Ø12.5mm
•
6x ISO 4762-A4 M12 mounting bolts (length as required for deck thickness)
•
6x M12 locking nuts and large washers (or backing plate to match drilling template)
•
Spanner, 19mm for mounting bolt locking nuts
•
Sealant / bedding compound
Step 1 Determine mounting location and orientation
Position the winch with the recommended line entry angle of 3-8° from horizontal. The self-
tailing arm should be positioned to allow the rope to drop clear of the winch as it feeds out of
the self-tailer. Positions will typically be as indicated by the shaded sectors in the diagram. The
self-tailing arm can be adjusted after installation into one of 12 different positions, as indicated
on the drilling template.
Note the drainage grooves on the underside of the winch base. If the mounting surface is not
horizontal due to deck camber or other factors, plan the installation such that water may drain
away from the winch base towards the lowest point in relation to the slope of the mounting
surface.
®
Drainage grooves
6