Andersen VeriLock 매뉴얼 - 페이지 3
{카테고리_이름} Andersen VeriLock에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen VeriLock 6 페이지. Security sensor lock
Andersen VeriLock에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지), 매뉴얼 (13 페이지), 애플리케이션 (10 페이지), 애플리케이션 (6 페이지), 매뉴얼 (6 페이지), 매뉴얼 (5 페이지), 서비스 매뉴얼 (6 페이지)
페이지 인쇄4
Interior
Unlock and open bottom sash.
Desbloquee y abra la hoja inferior.
6
Lock
Cerrojo
Interior
Position VeriLock assembly around lock as shown. Fasten using #8 x 1" color matched screws provided. Do not over tighten screws.
Position VeriLock assembly around lock as shown. Fasten using #8 x 1" color matched screws provided. Do not over tighten screws.
7
Interior
Clean area on lock handle to receive lock magnet with cleaning wipe provided. Remove adhesive liner press magnet firmly on lock handle with
arrow pointing up as shown.
Clean area on lock handle to receive lock magnet with cleaning wipe provided. Remove adhesive liner press magnet firmly on lock handle with
arrow pointing up as shown.
9142195
5
Interior
Remove screws from lock and dispose of properly. Do not remove or lift lock after unscrewing.
Retire los tornillos del cerrojo y deséchelos adecuadamente. Do not remove lock after
unscrewing.
VeriLock Assembly
VeriLock Assembly
Lock Handle
Lock Handle
Lock Magnet
Lock Magnet
Adhesive Liner
Adhesive Liner
Phillips Screwdriver
Destornillador
Phillips
Lock
Cerrojo
#8 x 1" Screw
#8 x 1" Screw
3
NOTE: VeriLock
sensor is installed
on the right lock
of units with two
locks, as viewed
from the interior.
NOTE: VeriLock
sensor is installed
on the right lock
of units with two
locks, as viewed
from the interior.
Position magnet as
shown with arrow
pointing up.
Position magnet as
shown with arrow
pointing up.