Community CLOUD 4 설치 매뉴얼 - 페이지 8

{카테고리_이름} Community CLOUD 4에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Community CLOUD 4 17 페이지. Community cloud series high output ceiling speakers

INSTALLATION AND WIRING

CAUTION:

ALWAYS USE THE

PROPER FITTING IN

ACCORDANCE WITH

YOUR AREA'S

BUILDING CODES

AND REGULATIONS

Step 4

Attach Wiring to the Removable Locking Connector

Connect the end of the wiring to the removable

locking connector that is included with the

speaker by stripping the insulation back about

5mm (1/5 inch), inserting the bare end of the

wire into the connector and screwing down the

hold-down screw until tight. Tighten any

unused screws to avoid vibration.

Using an Alternate Fitting – the existing strain relief

fitting accommodates many common fitting requirements.

Sometimes, alternate fittings are required, such as for

larger diameter conduit or to meet specific code

requirements.

In these cases, the existing fitting can be easily replaced

with a number of available off-the-shelf fittings. Simply

remove the existing fitting by unscrewing the two hold-

down screws, exposing a 7/8 inch (22mm) knockout hole.

Then, install the alternate fitting.

Figure 7-Attaching wires to connector

CLOUD 4 and CLOUD 6 – Installation Guide