Bosch Nexxt Series 작동, 관리 및 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Bosch Nexxt Series에 대한 작동, 관리 및 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Nexxt Series 27 페이지.
Bosch Nexxt Series에 대해서도 마찬가지입니다: 작동, 관리 및 설치 지침 매뉴얼 (26 페이지)

페이지 인쇄

Factory supplied

equipment

There is a packet of accessory parts

supplied with your washer. Check

that all the accessory parts supplied

for your model are there. If any parts

are missing contact your dealer

immediately.

Inside the drum:

Water supply hose for cold

water (blue marking).

Water supply hose for hot

water (red marking).

Water drain hose.

A bag which contains:

Covers to be placed over the

holes for the transport bolts

(after removing them).

Clamp for drain hose.

Wrench for levelling.

Elbow for attaching the drain

hose, e.g. to a sink.

Depending on the type of

connection, the following may also

be required:

Y connector (can be obtained

from any hardware store) in

case there is only a cold water

connection available.

Any residual moisture inside the

drum is due to the final testing

which every washing machine

undergoes before leaving the

factory.

On the rear of the appliance:

Power cord with plug.

C = cold water connection

H = hot water connection

Useful tools

The following tools are helpful:

Box cutter.

Flat head screwdriver.

Closed wrench (1/2"/13mm).

Bubble level.

Dimensions

a = 27.0 inches (686 mm)

b = 30.7 inches (780 mm)

c = 37.0 inches (940 mm)

d = 16.0 inches (407 mm)

Door opening angle 180°

Approx. weight = 220 lbs (100 kg)

Installation area

DANGER

Never ground the washer to

plastic plumbing lines, gas lines

or hot water pipes.

Appliance stability is important,

otherwise the washing machine

could "walk" during the spin cycles.

The installation area must be solid

and even. Soft floor surfaces, such

as carpets or surfaces with foam

backing, are not suitable.

If the washing machine is to be

installed on a weak wood floor

consider the following:

If possible, place the washing

machine in a corner of the

room.

Screw a water resistant

wooden board (at least 3/4"

thick) to the floor.

Secure the feet of the washing

machine with holding brackets.

Order the holding brackets (set)

from Bosch Customer Service

(WMZ 2200).

Pedestal Mounting

If mounting the washer on the

Bosch pedestal (accessory

no. WTZ1295) follow the instruc

tions supplied with the pedestal.

Install pedestal prior to

removing transport bolts.

Closet

If installing the washer in a closet,

observe the minimum distances

according to the following table:

Minimum Installation Clearances

Sides

1/4" (6 mm)

Top

12" (3O5 mm)

Rear

2,5" (64 mm)

Front

1/4" (6 mm)

Ventilation:

Top: 48 sq. in (310 sq. cm),

Bottom: 24 sq. in (155 sq. cm)

Closet