Anderson FFA10 운영 매뉴얼 - 페이지 8

{카테고리_이름} Anderson FFA10에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anderson FFA10 13 페이지.

Before installing the bracket, all position rulers should be checked first, and they

should be in the zero position, otherwise, the fixing bolts should be loosened first,

and set to zero. Adjust the bracket so that the four fixing bolts are in the middle of

the chute to ensure that the bracket can move in all directions.

Note: The bracket used in the side burn installation method and the bottom burn

installation method is not the same (as shown in the figure 2)

Fix the bracket on the steel structure. Allow the sealing plate to fit perfectly to the

burner brick. Use a positioning tube (sold separately) to position the bracket so that

the bracket can be installed in such a way that the sealing plate and the burner block

are concentric, and can be fitted without gaps with the burner block. Secure the

bracket so that it cannot be easily moved.

Move the burner bracket backward so that the seal plate and burner block are not

pushed, and there will be no force between due to thermal expansion during

furnace heat-up.

Use thermal insulation fiber to plug the burner block hole to prevent the heat in the

furnace from releasing out.

During furnace heat-up process, both the steel structure and the refractory block

will move due to expansion, and the burner holder needs to be readjusted.

Move out the insulation fiber from burner seal plate and burner block.

Before the furnace is ready to run, move the burner bracket forward so that the

center of the hole of the seal plate and the burner block is completely touching each

other, and the convex ring of the seal plate can fully enter the groove of the burner

block to ensure that the seal plate and the burner block are completely fitted.

Lack of cooling air will greatly reduce lifetime of the burner tip, gasket

6.2

Burner bracket fixing in position

Use the positioning tube (to be purchased separately) to position the bracket so that

the installation position of the bracket can ensure that the burner is concentric with

the seal plate and can be fitted with the seal plate without gap. After confirming

that the installation position of the bracket is basically the same as the drawing,

proceed to the next step, Otherwise, adjust the position of the burner bracket on

the steel structure.

Bracket position adjustment: Visually adjust the bracket position and height so that

the positioning tube on the bracket is concentric with the burner brick hole. Be

careful to keep the height of the bracket in the middle of the adjustment mechanism,

and determine the height of the support beam.

Push the bracket forward until the front end of the positioning tube is close to the

Anderson Thermal Soluions（Suzhou）Co., Ltd

Anderson Thermal Solutions –FFA10 Burner Operation Manual

Warning

seal plate!