CARNIVORE MM-12 사용 설명서 - 페이지 10

{카테고리_이름} CARNIVORE MM-12에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CARNIVORE MM-12 10 페이지. Electric meat mincer (240v) 180kg per hour mincing capacity

Page 10

FIG 6 - Components

1 - Lock nut

MAINTENANCE

7.1 GENERALITIES

Before servicing the appliance it must be disconnect from the electricity supply plug isolating the

appliance from the main power source.

7.2 FOOT SUPPORTS

In time the foot supports can deteriorate causing instability. If this is the case replaces them.

7.3 POWER SUPPLY CABLE

Periodically check for wear in the power cable and if necessary contact your nearest authorized repair

agent.

7.4 START/STOP PUSH BUTTONS

Over time the start/stop buttons could become damaged or broken. If this should happen contact your

nearest authorized repair agent for replacements.

7.5 DISK AND BLADE

Both the blade and disk can deteriorate in time. If this should happen contact the place of purchase for

original replacements.

7.6 LUBRICATION

The bearing is a sealed & pre-lubricated bearing requiring no on-going maintenance. It is suggested to

maintain the blade & disk surface with a thin film of food grade lubricant, do not use cooking oils as

these can tend to become rancid over time & could cause illness. Ensure the lubrication is specifically

designed for use on food processing machinery.

8 SCRAPPING

8.1 OUT OF SERVIE

If the appliance for some reason is to be put out of service, make sure it can no longer be used,

disconnect and remove all electrical connections & ensure the machine is safe & can't be run.

8.2 SCRAPPING

Once the appliance is out of service it can be scrapped. Contact a specialized company to scrap it

conforming to the materials used for manufacturing the various components.

www.machineryhouse.com.au

Instructions Manual for MM-12 (F330)

2 - Disk

3 - Blade

[Type here]

4 - Screw Feeder

5 - Mincer Block

www.machineryhouse.co.nz

10/06/2016