ANDILOG CENTOR FIRST II 사용자 설명서 - 페이지 7

{카테고리_이름} ANDILOG CENTOR FIRST II에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ANDILOG CENTOR FIRST II 12 페이지.

3. Using the CENTOR FIRST

User's manual

CENTOR FIRST II

3.1.

Start-up

Please note that the Centor First II measures very small changes in force and may not read exactly zero

if it is moved during its self-test procedure. When properly mounted and zeroed, the reading remains

stable.

To switch on, press the key

, a short self-test procedure displays the following screen

After the self-test, if the device is functional, the force gauge displays the measurement screen. It then

displays 0 N. A tare is performed when the device is started.

If the applied force is greater than 20% of the maximum capacity, the force gauge displays a

maintenance screen. At the bottom of this screen, the force applied in % is indicated. The unit is not

usable if the force at startup is greater than 20%. It is then necessary to turn off the force gauge and

remove the preload before turning it on again.

For example, for a force gauge with a capacity of 500N, the force applied to the sensor must not

exceed 100N at start-up.

- 7 -