ANDILOG CENTOR FIRST II Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади ANDILOG CENTOR FIRST II. ANDILOG CENTOR FIRST II 12 сторінок.

3. Using the CENTOR FIRST

User's manual

CENTOR FIRST II

3.1.

Start-up

Please note that the Centor First II measures very small changes in force and may not read exactly zero

if it is moved during its self-test procedure. When properly mounted and zeroed, the reading remains

stable.

To switch on, press the key

, a short self-test procedure displays the following screen

After the self-test, if the device is functional, the force gauge displays the measurement screen. It then

displays 0 N. A tare is performed when the device is started.

If the applied force is greater than 20% of the maximum capacity, the force gauge displays a

maintenance screen. At the bottom of this screen, the force applied in % is indicated. The unit is not

usable if the force at startup is greater than 20%. It is then necessary to turn off the force gauge and

remove the preload before turning it on again.

For example, for a force gauge with a capacity of 500N, the force applied to the sensor must not

exceed 100N at start-up.

- 7 -