Drehmo i-matic 설치 및 운영 매뉴얼 - 페이지 13

{카테고리_이름} Drehmo i-matic에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drehmo i-matic 18 페이지. Electrical actuator with integral controls
Drehmo i-matic에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

페이지 인쇄

Supplement operating manual for DREHMO i-Matic actuators with integrated

Insight view on DREHMO i-Matic compact plug

Dual cable conduits with metric

(standard) winding for cable

glands:

M 32 x 1.5 mm (standard)

PG 29 (optional)

Device is shipped with blind plugs

The wiring of the bus lines A(-), B(+), has to be done according to the given labels on the

corresponding terminals. Cables coming from the master have to be connected on the input

terminals (labeled IN) and the cables going to the end of the segment have to be wired to

the output terminals (labeled OUT). The connection of the shielding for incoming or

outgoing cables has to be done in the same manner.

Wenden, 21.03.12

Prepared by: Ste

MODBUS fieldbus interface

Compact plug housing

Mounting plate with electric assembly

(front side view)

Power connector

Control connector

Wiring board

O-ring seal

Single cable conduit with metric

(standard) winding for cable gland:

M 20 x 1.5 mm (standard)

PG 13.5 (optional)

Device is shipped with blind plugs

Slide switches for bus termination

Slide switches for shield grounding

Page 13 of 18