Drehmo i-matic Instrukcja instalacji i obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Kontroler Drehmo i-matic. Drehmo i-matic 18 stron. Electrical actuator with integral controls
Również dla Drehmo i-matic: Instrukcja obsługi (20 strony)
Drukuj stronęSupplement operating manual for DREHMO i-Matic actuators with integrated
Insight view on DREHMO i-Matic compact plug
Dual cable conduits with metric
(standard) winding for cable
glands:
M 32 x 1.5 mm (standard)
PG 29 (optional)
Device is shipped with blind plugs
The wiring of the bus lines A(-), B(+), has to be done according to the given labels on the
corresponding terminals. Cables coming from the master have to be connected on the input
terminals (labeled IN) and the cables going to the end of the segment have to be wired to
the output terminals (labeled OUT). The connection of the shielding for incoming or
outgoing cables has to be done in the same manner.
Wenden, 21.03.12
Prepared by: Ste
MODBUS fieldbus interface
Compact plug housing
Mounting plate with electric assembly
(front side view)
Power connector
Control connector
Wiring board
O-ring seal
Single cable conduit with metric
(standard) winding for cable gland:
M 20 x 1.5 mm (standard)
PG 13.5 (optional)
Device is shipped with blind plugs
Slide switches for bus termination
Slide switches for shield grounding
Page 13 of 18