Drehmo i-matic 설치 및 운영 매뉴얼 - 페이지 4
{카테고리_이름} Drehmo i-matic에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drehmo i-matic 18 페이지. Electrical actuator with integral controls
Drehmo i-matic에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)
페이지 인쇄Supplement operating manual for DREHMO i-Matic actuators with integrated
2.2 Supported function codes
Among the list of possible modbus functions as described in the modbus guidelines, the following function
codes are supported:
FC 01
Read Coil Status
FC 02
Read Input Status
FC 03
Read Holding Registers
FC 04
Read Input Registers
FC 05
Force Single Coil
FC 06
Preset Single Register
FC 15
Force Multiple Coils
FC 16
Preset Multiple Registers
FC 17
Report Slave ID
2.3 Data model
The discrete single bit command and status bits for the actuator are mapped in a linear addressable structure.
Each command or status bit can be accessed individually. The commands are also addressable as single or
multiple words.
The reserved addresses for input and output data are as follows:
Coil addresses: range 1 (Hex 0x01 to 512 (Hex 0x200) results in 512 coils reserved
Register addresses: range 513 (Hex 0x201) to 544 (Hex 0x220) results in 32 registers reserved
Wenden, 21.03.12
Prepared by: Ste
MODBUS fieldbus interface
read single bit of master output data (command check)
read single bit as input to master (bit feedback)
read back of master output data as integer (command check)
read data as input to master (word feedback)
write single bit of master output data (command)
write single data of master output data (command)
write multiple bit of master output data (commands)
write multiple data of master output data (commands)
Read TAG/KKS
Page 4 of 18