Drehmo 384771 추가 운영 매뉴얼 - 페이지 7

{카테고리_이름} Drehmo 384771에 대한 추가 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drehmo 384771 12 페이지. Simc with limit switching unit

1. COMMISSIONING

There is a gear wheel at the bottom of the base plate. The ﬁgure 1.4 shows the version for

section III. For section II there would be a big instead of a little gear wheel. The opposite

gear wheel is mounted on an output drive of the actuator.

Figure 1.4: limit switching unit input drive gear wheel

The reduction gearing is available for a range between 1.38

is divided into two sections: III (1.38

wheel) and II (12.4

between these ranges requires exchanging the gear wheels on the bottom of the limit switch

base plate. By moving the sliding wheel in one of the positions 4

range can be selected.

Additional operating manual

Figure 1.3: Reduction gearing

135 turns/stroke, large gear wheel to small gear

1450 turns/stroke; small gear wheel to large gear wheel). Changing

1. Shaft of the mechanical position in-

dicator

2. Sliding wheel

3. Scale with possible setting ranges

for the travel

4. Fixing screw for the sliding wheel

1,450 turns/stroke. The range

11, the required travel