Drehmo i-matic 사용 설명서 - 페이지 11
{카테고리_이름} Drehmo i-matic에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Drehmo i-matic 20 페이지. Electrical actuator with integral controls
Drehmo i-matic에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (18 페이지)
- 1. Connection on Matic C Base Plate DMC - 02 (Since Hw Rev. 5)
- 2. Connection on I-Matic Interface Unit DIM - 09 (Devicenet)
- 3. Connection on Matic C Display Unit DMC - 30 (Lcd Display Unit)
- 4. Connection on I-Matic Display Unit DIM - 02 (Ir / Irii)
- 5. Connection on I-Matic Interface Unit DIM - 17 (Modbus Loop)
3 Connectivity
3.1 SER01 adaptor
The SER01 adaptor enables the access by means of a 5 pole female reverse polarity
protected connector. By means of an integrated push button, a reset of the attached
electronic unit can be forced.
3.1.1 Connection on Matic C base plate DMC - 02 (since HW Rev. 5)
The following pictures show the position of the interface connector for the SER01 adaptor on
the DMC - 02 unit - available for hardware revision 5 or higher.
Attention:
In case of a mounted DMC - 14 unit (Profibus DP-V1 interface) the usage of this connection
is restricted. The direct serial access to the base board requires in any case the dismount of
the interface unit DMC - 14.
DREHMO
Instruction manual for USB adaptor kit
page 11 of 20