Drehmo i-matic 사용 설명서 - 페이지 14
{카테고리_이름} Drehmo i-matic에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Drehmo i-matic 20 페이지. Electrical actuator with integral controls
Drehmo i-matic에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (18 페이지)
페이지 인쇄- 1. Connection on Matic C Base Plate DMC - 02 (Since Hw Rev. 5)
- 2. Connection on I-Matic Interface Unit DIM - 09 (Devicenet)
- 3. Connection on Matic C Display Unit DMC - 30 (Lcd Display Unit)
- 4. Connection on I-Matic Display Unit DIM - 02 (Ir / Irii)
- 5. Connection on I-Matic Interface Unit DIM - 17 (Modbus Loop)
3.2 SER02 adaptor
The SER02 adaptor enables the serial access by means of a 4 pole female socket connector
matching on a corresponding 4 pole pin connector in 2,54mm pitch. Reverse polarity
protection is given by means of the special outline geometry of the adaptor board itself.
3.2.1 Connection on i-matic display unit DiM - 02 (IR / IrII)
The following picture shows the position of the interface connector for the SER02 adaptor on
the DiM - 02 unit.
The correct plug in polarity of the adaptor is only given, if the expanded finger like
board outline fits aside the display board edge.
DREHMO
Instruction manual for USB adaptor kit
page 14 of 20