Dremel 3D20 Idea Builder 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Dremel 3D20 Idea Builder에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dremel 3D20 Idea Builder 8 페이지. Unclogging
Dremel 3D20 Idea Builder에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (2 페이지), 문제 해결 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄
Dremel 3D20 Idea Builder 빠른 시작 매뉴얼
5
Getting Ready to Build (continued...)
LEVELING BUILD PLATFORM
1. Tap "Tools" on your Dremel 3D20's touch screen and
tap "Level" .
2. First level the front left of the build platform.
3. Place the leveling sheet between the extruder and build
platform.
a) If the leveling sheet cannot slide between the extruder
and build platform, turn the knob counterclockwise until
you can slide the leveling sheet between the extruder and
build platform with some resistance.
b) If the leveling sheet can slide between the extruder and
build platform too easily, turn the knob clockwise until you
can slide the leveling sheet between the extruder and build
platform with some resistance.
4. Tap "Next" to move the build platform toward the right knob
and repeat step above.
5 Tap "Next" to move the build platform toward the rear knob
and repeat step above.
6. Tap "Finish" to complete the leveling process.
1
3
WARM
STEP 2: RIGHT ADJUSTMENT
NEXT
TURN
LEFT
TO
RAISE
THE BUILD PLATFORM
TURN
RIGHT
TO
LOWER
BACK
THE BUILD PLATFORM
4
WARM
STEP 1: LEFT ADJUSTMENT
NEXT
TURN
LEFT
TO
RAISE
THE BUILD PLATFORM
TURN
RIGHT
TO
LOWER
BACK
THE BUILD PLATFORM
2
TURN LEFT TO RAISE
THE BUILD PLATFORM
TURN RIGHT TO LOWER
WARM
STEP 3: BACK ADJUSTMENT
NEXT
TURN
LEFT
TO
RAISE
THE BUILD PLATFORM
TURN
RIGHT
TO
LOWER
BACK
THE BUILD PLATFORM
5