Dremel 3D40 Idea Builder 매뉴얼 - 페이지 2

{카테고리_이름} Dremel 3D40 Idea Builder에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dremel 3D40 Idea Builder 4 페이지. Clogged heatsink tube replacement
Dremel 3D40 Idea Builder에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 지침 (5 페이지), 서비스 지침 (2 페이지)

페이지 인쇄

Step 2: Remove Top Cover of Extruder

a. Cut the filament just before the intake on the top of the

extruder.

b. Unscrew the two screws on the top of the filament

guide bracket.

c. Remove the top cover.

d. Carefully unplug filament runout switch from the ex-

truder circuit board, ensuring to pull from the plastic

plug and not the wires; pulling the wires can damage

the connection to the extruder. Please see picture

below.

SERVICE

Step 3: Remove the Extruder Motor

a. Disconnect the white extruder terminal block from the

extruder connector as shown in the picture below. En-

sure to grab the block and avoid pinching the wires.

b. Unscrew the two extruder screws as shown in the pic-

ture below. Please ensure that the screws once fully

unscrewed, should still be left inserted in the extruder

chassis hole.

c. Pull the extruder away from the printer (vertically) as

shown in the picture below.

d. Cut the filament as close to the nozzle tube top as pos-

sible and dispose of that piece of filament.