Andonstar AD206S 사용자 설명서 - 페이지 8

{카테고리_이름} Andonstar AD206S에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Andonstar AD206S 11 페이지.

Image switching

When connecting the endoscope to the microscope,

pay attention to the direction of the plug. Refer to

the schematic diagram in Figure9:

Note: 1.After the endoscope is connected to the main device,

please do not swing left or right to

avoid poor contact of the endoscope; 2. The endoscope does not support functions such as remote

control, capture, and video recording.

(Figure9 Schematic diagram of endoscope interface)

After the endoscope is connected, its image does not appear on the screen immediately. You need to

press the "V" key (image switching key, Figure 8/④), the remote control "NTL/PAL" key has the

same function).

The process of image switching is shown in Figure 10. Through the "V" key, the endoscope image can

be switched: from small to full screen. If you don't need the endoscope image, you can continue to

press the "V" key to switch to the microscope image or not connect to the endoscope.

Press the "V" key for the first time to achieve dual-screen display; press the "V" key for the second time

to display the endoscope image; press "V" for the third time to switch to the microscope image.

(Figure10 Schematic diagram of the screen switching process)