Dremel DigiLab 3D45 매뉴얼 - 페이지 3

{카테고리_이름} Dremel DigiLab 3D45에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dremel DigiLab 3D45 4 페이지. Print removal
Dremel DigiLab 3D45에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 서비스 지침 (4 페이지), 사용 설명서 (2 페이지), 서비스 매뉴얼 (4 페이지), 캘리브레이션 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

D) Check for Clogs in Stepper Motor:

Use proper anti-static precautions

when performing this replacement.

Discharge static electricity before beginning. Work on a

static-free surface.

It is possible for filament to get stuck on the stepper motor,

or to have a buildup of filament on the stepper motor drive

gear (gear used to move filament through the extruder). To

clean up the stepper motor drive gear, it is required to disas-

semble the extruder.

Follow the instructions below to disassembly your extruder

and clean the stepper motor gear.

1. Bring Printer to Safe State for Service.

a. Turn on the printer, and verify that the temperature icon

reads cool (see thermometer icon empty), if it is not cool

(full thermometer), allow adequate time for the nozzle

and bed to cool.

b. Turn off the printer

c. Unplug the printer

2. Remove Top Cover on the Extruder.

a. Cut the filament just before the intake on the top of the

extruder.

Hot

Cool

b. Remove screw located on the right side of the hole

using the T10 Torx screwdriver. The first picture below

shows the location of the screw, the second picture a

bottom view of the area where the screw is located,

circled in red is the screw that needs to be removed.

c. Unscrew the two screws on the top of the filament guide

bracket using the 2.5mm bit or Hex wrench

d. Remove the top cover.

e. Carefully unplug filament run out switch from the

extruder circuit board, ensuring to pull from the plastic

plug and not the wires; pulling the wires can damage

the connection to the extruder. Please see picture

below.