andover Model-One 제품 설명서 - 페이지 10

{카테고리_이름} andover Model-One에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. andover Model-One 14 페이지. Modular stand system
andover Model-One에 대해서도 마찬가지입니다: 제품 설명서 (19 페이지), 제품 설명서 (8 페이지)

페이지 인쇄
andover Model-One 제품 설명서
Back Panel
Power Inlet

Making the Initial Connections

1. Connect the power cord into the AC power input connector and plug the
other end into a grounded wall outlet.
2. Connect an RCA cable from the Subwoofer output of the source component
into the RCA jack input.
3. Switch the power switch adjacent to the AC input ON.
4. Switch the Power mode switch to the AUTO (middle) position.
If using the Model-One Turntable music system, set the Volume and Frequency
knobs to their center detent position. This is our factory-recommended setting.
Once the system is installed and operating, you may freely adjust these controls
to your taste.
The LED adjacent to the Power Mode switch indicates operating status. A Red
LED indicates the subwoofer is on and in Standby. When a signal is present,
the LED will turn green and the subwoofer will be active. After a few minutes of
silence, the woofer will return to Standby.
Power
Power Mode
Page 10
Input (RCA) Volume Low Pass