andover Model-One Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сабвуфер andover Model-One. andover Model-One 14 страниц. Modular stand system
Также для andover Model-One: Руководство по эксплуатации (19 страниц), Руководство по эксплуатации (8 страниц)

Back Panel

Power Inlet

Making the Initial Connections

1. Connect the power cord into the AC power input connector and plug the

other end into a grounded wall outlet.

2. Connect an RCA cable from the Subwoofer output of the source component

into the RCA jack input.

3. Switch the power switch adjacent to the AC input ON.

4. Switch the Power mode switch to the AUTO (middle) position.

If using the Model-One Turntable music system, set the Volume and Frequency

knobs to their center detent position. This is our factory-recommended setting.

Once the system is installed and operating, you may freely adjust these controls

to your taste.

The LED adjacent to the Power Mode switch indicates operating status. A Red

LED indicates the subwoofer is on and in Standby. When a signal is present,

the LED will turn green and the subwoofer will be active. After a few minutes of

silence, the woofer will return to Standby.

Power

Power Mode

Page 10

Input (RCA) Volume Low Pass