AirTech Air+ PIV 설치 및 커미셔닝 지침 - 페이지 6

{카테고리_이름} AirTech Air+ PIV에 대한 설치 및 커미셔닝 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AirTech Air+ PIV 16 페이지. Positive input ventilation unit
AirTech Air+ PIV에 대해서도 마찬가지입니다: 설치 및 커미셔닝 지침 (16 페이지)

페이지 인쇄

Hanging method:

The Air+ PIV can be hung from a roof beam (Fig. 2).

roof beam.

Use the cord provided to loop through the eye and around the handle on the

unit, there are various notches for the cord to run through, tie the two ends together

using a suitable knot such as an over hand or fisherman's knot.

Ensure that the route for the flexible ducting has gentle bends and that the duct

cannot be crushed.

Fit the filters to the unit.

This will ensure that all the fresh air entering the dwelling has passed through the

filter first.

Ensure that the screw eye is attached to the beam strongly enough and that the beam is

in sufficient condition to withstand the load.

Floor mounting:

Find a suitable location to fix the unit near to where the diffuser is to be located.

Ensure that the route for the flexible ducting has gentle bends and that the duct

cannot be crushed.

Affix the mounting base to a wooden board or two lengths of timber which can then be

screwed to the joists.

Place the unit in the mounting base cradle; two retaining pins hold the unit in place.

Fit the filters to the unit.

This will ensure that all the fresh air entering the dwelling has passed through the

filter first.

Please make sure that the filter is fitted correctly.

(USING ACCESSORY MOUNTING BASE – 477749 – Not supplied)

Please make sure that the filter is fitted correctly.

Fig. 3.

Fix the screw eye to a convenient

The unit weight is approximately 4 kg.

Fig.2.

Filters

Fig. 4.