AirTech Air+ PIV 설치 및 커미셔닝 지침 - 페이지 8
{카테고리_이름} AirTech Air+ PIV에 대한 설치 및 커미셔닝 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AirTech Air+ PIV 16 페이지. Positive input ventilation unit
AirTech Air+ PIV에 대해서도 마찬가지입니다: 설치 및 커미셔닝 지침 (16 페이지)
페이지 인쇄
Heater Unit
The heater unit can be mounted either to the unit or to the diffuser spigot, see Fig
7, where fitted to the unit there are locating pins that fix the heater to the unit
using a bayonet fitting and the locking screw. When fitted at the diffuser end, make
sure the direction of the heater is facing the correct way, arrow label on heater must
point towards diffuser. The power and sensor cables must be plugged in to the front of
the fan unit; see Fig 8.
Fig. 7.
Fig. 8.
C. WIRING
WARNING: THE POSITIVE VENTILATIION UNIT AND ANCILLARY
CONTROL EQUIPMENT MUST BE ISOLATED FROM THE POWER
SUPPLY DURING THE INSTALLATION / OR MAINTENANCE.
A MEANS FOR DISCONNECTION MUST BE INCORPORATED IN THE FIXED WIRING IN ACCORDANCE WITH
THE WIRING REGULATIONS.
Mains supply voltages (220-240V ac) are present in this equipment which may cause
death or serious injury by electric shock. Only a qualified electrician or installer
should connect the power supply to this unit.
The Air+ PIV is designed for operation from a single-phase alternating current source
(220-240V AC).
A 2m integral mains flying lead is connected to the unit for connection to a 3A
switched fused spur.
contact separation of at least 3mm.
Apply worm drive clips provided
in positions shown
Unit Mounted
It should be capable of disconnecting all poles, having a
Apply worm drive clips provided
in positions shown
Apply suitable duct tape to seal
between heater and diffuser.
8
Diffuser Mounted