Electrolux E:Line ERCG9030AS 설치 및 사용자 설명서 - 페이지 9
{카테고리_이름} Electrolux E:Line ERCG9030AS에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux E:Line ERCG9030AS 12 페이지. Electrolux e:line canopy rangehoods
Electrolux E:Line ERCG9030AS에 대해서도 마찬가지입니다: 설치 및 사용자 설명서 (7 페이지)
페이지 인쇄
Maintenance and cleaning
• B efore maintenance or cleaning is carried out,
the canopy rangehood should be disconnected
from the main power supply. Ensure that the
rangehood is switched off at the wall socket
and the plug removed.
• E xternal surfaces are susceptible to scratches
and abrasions, so please follow the cleaning
instructions to ensure the best possible result is
achieved without damage.
Stainless steel surface
Clean stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel.
To ensure best results also use an even pressure and follow
the grain of the stainless steel. Use of a soft cloth reduces
the risk of scratching. If the cloth is wet ensure that a dry
soft cloth is used to wipe down the surface again reducing
the risk of any surface rust appearing.
Control panel surface
The inlay control panel can be cleaned using warm soapy
water. Ensure the cloth is well wrung before cleaning.
Use a dry soft cloth to remove any excess moisture left
after cleaning.
Grease filters
The mesh filters can be cleaned either by hand or in
the dishwasher. After cleaning ensure that the filters are
completely dry before refitting.
By hand: Soak in warm water and some washing up liquid.
For stubborn grease stains use a soft nylon brush to help
remove these stains.
In a dishwasher: Ensure that placement of the filters
is made so as to not impede the function of the spray
arm. Washing the filters in a dishwasher may cause
discolouration of the aluminium inner mesh over time
although it will not affect their performance. Filters should
be washed separately to crockery and kitchen utensils.
Glass fascia
The glass fascia on model ERCG9030AS can be cleaned
with window cleaner or a mild detergent and hot water and
paper towelling.
electrolux e:line rangehoods maintenance / halogen lamps 8
Changing the halogen lamps
Using a small flat blade screwdriver remove the inner
stainless steel ring to obtain access to the halogen globe.
When removing the inner ring, do so carefully, as the glass
lens could easily fall out of the inner ring. Remove halogen
globe, whilst cool, and replace carefully with a new globe.
The rangehood takes 2 x 20W, 12 volt halogen globes.
When handling globes hold with a cloth or gloves to ensure
perspiration does not come in contact with the globe as this
can reduce the life of the globe.