Atlantic SP1600 사용 설명서 - 페이지 16
{카테고리_이름} Atlantic SP1600에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic SP1600 16 페이지. Oasis series skimmer, filterfalls, pump vault, fastfalls
Atlantic SP1600에 대해서도 마찬가지입니다: 제품 설명서 (12 페이지)
페이지 인쇄AF1000 AUTO FILL KIT
Labeled drill points have been provided for
the proper Auto Fill location on either side of
the Oasis Skimmer and Pump Vault (Figure
K). It is a good idea to completely install the
pump, check valve assembly, and discharge
hose before you drill for the Auto Fill. This
will help you determine the best side of the
Skimmer or Pump Vault to place the Auto Fill
so that it has proper clearance on all sides.
Once you have determined the location of
the Auto Fill, drill a 7/8" hole using a spade bit
or hole saw. Insert the Auto Fill making sure
the gasket is on the inside of the enclosure
and the plastic retaining nut is on the outside.
Tighten the retaining nut until snug. Do not
over-tighten the retaining nut (Figure J).
Fittings to connect the Auto Fill to a garden
hose, ½" irrigation line, and ½" Sch40 PVC
are included in the kit. Wrap the ½" male
threads on the Auto Fill with thread
sealant and install the fitting of your choice.
Once water is supplied to the Auto Fill it will
maintain the set water level by automatically
adding water when the level drops. This level
can be adjusted by loosening the wing nut
and raising and lowering the height of the
Auto Fill float. Use the water line mark on
the weir door frame to help establish proper
water level.
OVERFLOW
A drill-point has been provided on the back
of the Oasis Skimmer and Pump Vault to show
the proper location and elevation to install
an Atlantic HA2000 bulkhead fitting for the
overflow (not included). See Figure K above
for drill-point location. This combination will
position the bottom of the overflow pipe
approximately 1" above recommended water level. (Note: If a HA2000 bulkhead is not
being used, the center point for the hole will have to be recalculated on site.)
Drill a 3" hole and install the bulkhead following the instructions on page 8. Install a 2"
MTA and connect the overflow pipe. Apply silicone on the threads of the Male Thread
Adaptor (MTA). Screw the MTA into the bulkhead until tight. Use PVC Glue (not included)
to glue the PVC flex hose into the MTA.
16
Figure J.
RETAINING
NUT
FITTING
Figure K.
GASKET
VALVE
OVERFLOW
PUMP DISCHARGE
AF1000 AUTO FILL
OVERFLOW
PUMP DISCHARGE
AF1000 AUTO FILL