Atlantic SP1600 사용 설명서 - 페이지 7

{카테고리_이름} Atlantic SP1600에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic SP1600 16 페이지. Oasis series skimmer, filterfalls, pump vault, fastfalls
Atlantic SP1600에 대해서도 마찬가지입니다: 제품 설명서 (12 페이지)

페이지 인쇄

1. Setting the Bf1600

When you are finished, remove the spring clips and pull the liner away from the face

of the skimmer. Apply a consistent bead of Atlantic fish-safe silicone to the face of the

Skimmer along the centerline of the pre-drilled bolt holes. Once you are finished, you can

return the liner to its original position and replace the spring clips.

Figure 6.

ATTACHING THE WEIR DOOR

Unlatch the weir door and lower the door to its fully

open position. Insert the weir door assembly into the

Skimmer opening. With one hand push the bottom

of the weir door frame tight against the Skimmer

face. With the other hand gently push down on the

weir door latch until it clears the top of the opening.

Once it does, push the weir door assembly into the

Skimmer opening until the frame rests against the

face of the enclosure (Figure 7).

Line up the holes of the weir door frame with the

holes in the Skimmer face. Use a nail or awl to help

line up the holes and pierce the liner in the top

corners. Loosely fasten the top corners using two

of the supplied 1/4-20 machine screws and serrated

flange nuts. Next, install two screws in the bottom

corners of the weir door frame (Figure 8).

Once you have the weir door tacked at the corners

you can install the rest of the screws. Do not fully

tighten any screws until all of the screws have been

installed.

Use your fingers to hold the flange nut and a hand held screwdriver to tighten

the screws. The serrations on the flange nut will grab the plastic enclosure once it

makes contact, eliminating the need to use a wrench. Use caution when tightening

the screws. The screws need only be snug for the silicone to make a seal.

Figure 7.

Figure 8.