Atlantic FP500-75474 제품 설명서 - 페이지 2

{카테고리_이름} Atlantic FP500-75474에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic FP500-75474 17 페이지.

페이지 인쇄

Introduction

Thank you for purchasing the TidalWave FP100, FP200, FP300, FP400 or FP500 series

pump. Before using this pump please take a moment to review this manual.

To avoid an accident do not use the pump in any way other than as described in this

manual. Please note the manufacturer cannot be responsible for accidents arising because

the product was not used as prescribed. After reading this manual keep it as a reference in

case questions arise during use.

Flow Chart: (GPH)

MODEL

MAX FLOW

FP100

120

FP200

175

FP300

325

FP400

370

FP500

525

Prior to Operation and Installation

When the pump is delivered, first perform the following checks:

• Check for any damage to pump and power cable that may have occurred during

the shipment.

• Check the model number to make sure it is the product that was ordered and verify the

voltage and frequency are correct.

Caution

• DO NOT operate this product under any condition other than those for which it is specified.

Failure to observe this precaution can lead to electrical shock, electrical leakage, fire, water

leakage or other problems.

• The pump is a 110/120 volt 60 Hz pump, please only use with a power supply voltage within

110-120 volt 60 Hz.

• Never place your hand or any object in or near the inlet opening while this equipment is

operating. If pump inlet is clogged, always turn off the power supply and wait until the

motor is completely stopped before attempting to remove any clogged material.

• Please make sure that the power plug and the AC outlet receptacle are protected and away

from water or pump discharge hose to prevent accidental electric shock or short circuit.

• Always operate the pump completely submerged in water.

• Avoid dry operation, which will not only lower performance but can cause the pump to

overheat/malfunction, leading to electrical leakage, shock or premature failure.

• Always turn off power or unplug the pump prior to performing any maintenance or placing

your hands into the water.

• CAUTION:

THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.

• CAUTION:

THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.

2.5'

100

230

290

430

180

300

7.5'