Atlantic FP500-75474 제품 설명서 - 페이지 4

{카테고리_이름} Atlantic FP500-75474에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic FP500-75474 17 페이지.

• In case of excessive vibration, unusual noise or odor, turn off the power immediately and

consult your nearest dealer.

Maintenance and Inspection

• Regular maintenance and inspections are a necessity for continued efficient functioning. If

any abnormal conditions are noticed, refer to the section on Troubleshooting and take

corrective measures immediately.

Monthly Inspection / Cleaning

• Check for any drop in performance. Reduced performance is usually caused by debris

blocking the pump intake.

• Detach the power cable from the receptacle or turn off the power supply (circuit breaker).

• Disconnect the pump discharge and remove the pump from the water.

• Remove any accumulated debris from the surface of the pump and pre-filter.

• Remove the pre-filter, inspect the adjustable flow and remove any accumulated debris.

• Remove the threaded inlet cover by rotating it in a counterclockwise half turn while pulling

lightly outward from the pump body.

• Inspect the impeller and remove any debris that may be present.

• Spin the impeller. If the impeller is difficult to turn, feels "gritty", or a grinding noise is

evident in the rotor chamber, remove the rotor as per the instructions below.

• Remove the impeller assembly by pulling outward from the rotor chamber.

Note: The impeller assembly is comprised of six individual parts shown in the image below.

Take care not to lose or misplace any of these pieces during the cleaning process.

Pre-filter

Threaded

Inlet Cover

Flow Adjustor

Rubber

Bushing

Friction

Washer

Ceramic Shaft

Rotor

Chamber

Impeller

Assembly

Rubber

Bushing

Friction

Impeller/

Washer

Magnetic Rotor

Pump Body/Motor

Rubber Feet