DRI Sleeper Eclipse 사용 설명서 - 페이지 7

{카테고리_이름} DRI Sleeper Eclipse에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DRI Sleeper Eclipse 11 페이지.
DRI Sleeper Eclipse에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

2. The alarm base will start to beep slowly at one second intervals as it 'listens'

for the Urosensor

something metal across the sensing strips so that it is sending a signal to the

alarm base. When the alarm base detects the new Urosensor

rapidly five times. This means the Urosensor

3. If the alarm does not detect the new Urosensor

slowly for approximately 75 seconds and then will sound one long beep

indicating that it has not been able to detect the device. It is then necessary to

repeat the pairing process.

Note: Only one Urosensor

base cannot detect multiple sensors. Whichever Urosensor

the alarm, only that Urosensor

bases can be used with one Urosensor

My child wets the bed and the Urosensor

Test that the alarm and Urosensor

steps:

1. Switch the alarm on. It should beep rapidly five times.

2. Wrap the Urosensor

tissue. Stand 2-3 metres (yards) away from the alarm with your back to it and

drip ½-1 teaspoon of warm water on the Urosensor

2-3 seconds.

Note: Be careful not to touch the black sensing strips with your fingers as damp

skin can trigger the alarm.

3. If the alarm triggers then it is working correctly. The issue will be how the

Urosensor

™

4. Read instructions 3 & 4 of the section on How to use your DRI Sleeper

eclipse, or experiment with other methods of locating the Urosensor

section on Other ways to position the Urosensor

5. Always make sure the Urosensor

sensing strips after it has triggered the alarm to ensure that it will reset and

be able to trigger the alarm again. If it is not dried completely it will not reset

and won't be able to trigger the alarm if your child wets the bed.

6. Always make sure that the alarm is turned back on after a bedwetting event

if the Urosensor

. Immediately activate the Urosensor

™

can be used at a time with an alarm. A single alarm

™

will trigger the alarm. However, multiple alarm

™

Troubleshooting

in half a 2-3 ply paper handkerchief or some toilet

™

is being placed.

is being used again.

™

does not trigger the alarm.

™

are working correctly by following these

™

has been dried completely between the

™

– 7 –

by putting

™

it will beep

™

is now paired to the alarm base.

it will continue to beep

™

is last paired with

™

. It should trigger within

™

in underwear.

™

in the

™