Electrolux Icon E36WC45FSS 사용 및 관리 매뉴얼 설치 지침 - 페이지 13
{카테고리_이름} Electrolux Icon E36WC45FSS에 대한 사용 및 관리 매뉴얼 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux Icon E36WC45FSS 24 페이지. Electrolux e36wc45fss range hood: supplementary guide
Electrolux Icon E36WC45FSS에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 공장 부품 카탈로그 (4 페이지), 사용 및 관리 매뉴얼 (24 페이지)
페이지 인쇄
INSTALL THE DUCTWORK
CAUTION
To reduce the risk of fire, use only metal ductwork.
1 Decide where the ductwork will run between the hood and the outside.
2 A straight, short duct run will allow the hood to perform most efficiently.
3 Long duct runs, elbows, and transitions will reduce the performance
of the hood. Use as few of them as possible. Larger ducting may be
required for best performance with longer duct runs.
4 Install a roof or wall cap. Connect round metal ductwork to cap and
work back towards hood location. Use duct tape to seal the joints
between ductwork sections.
INSTALL THE ELECTRICAL
WARNING
Electrical wiring must be done by a qualified person(s) in accordance with all
applicable codes and standards. This range hood must be properly grounded.
Turn off electrical power at service entrance before wiring.
1 Plan where the hood will be located above the cook top. Refer to the
"INSTALL MOUNTING BRACKET" section for hood mounting height
options.
2 Install a standard 2" x 4" wall outlet box and 3-blade 125 volt, 15Amp
grounded receptacle.
3 Mount the receptacle 18" to 22" above the bottom of the hood.
4 Locate the receptacle within boundary shown and off center of the
ductwork (to allow for power cord plug and flue clearance).
Installation
DECORATIVE
FLUE
HOOD
24" TO 30" ABOVE
COOKING SURFACE
(See "Install mounting
bracket" section, for
mounting restrictions)
13
ROOF CAP
ROUND DUCT
WALL
CAP
ROUND
ELBOW
6"
ADAPTER
Figure 5
9"
4-1/2"
18"- 22"
Figure 6