Electrolux RH30WC40GS 설치, 사용 및 관리 매뉴얼 - 페이지 10

{카테고리_이름} Electrolux RH30WC40GS에 대한 설치, 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux RH30WC40GS 19 페이지. Universal/multiflex
Electrolux RH30WC40GS에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지), 공장 부품 카탈로그 (4 페이지)

페이지 인쇄

1. Filters

Installing the hood

Step 6

For r

ectangular ducted discharge installations only

For r

For rectangular ducted discharge installations only

For r

ectangular ducted discharge installations only

(otherwise skip to next step)

Attach exhaust adaptor/damper over knockout

Attach exhaust adaptor/damper

opening with two exhaust adaptor screws. Make

sure

damper pivot

pivot

pivot is nearest to top/back edge

pivot

Remove tape

tape

tape from damper flap.

tape

Pivot

NOTE: The exhaust adaptor/damper can be installed

NOTE:

up to 1 inch on either side of the hood center to

accommodate off-center ductwork. In extreme off-

center installations, one end of the duct connector

may need to be trimmed to clear the electrical cable

clamp.

Step 7

For round ducted discharge installations only

For r

ound ducted discharge installations only

For r

ound ducted discharge installations only

Re-install the r r r r r ound transition

7" Round

Transition

NOTE:

NOTE: The round transition can be installed up to 1

inch on either side of the hood center to

accommodate off-center ductwork. In extreme off-

center installations, one end of the duct connector

may need to be trimmed to clear the electrical cable

clamp.

top/back edge of hood.

top/back edge

Top/back

edge

Exhaust

transition/damper

ound transition

ound transition with its screws.

ound transition

Step 8

Mark holes

Select the vent option that your installation will

require and proceed to that section:

Outside top exhaust

(Vertical duct– 3 1/4"x 10" Rectangular)

Use the diagram or the hood as a template and mark

the locations on the cabinet for ductwork, electrical

wiring and keyhole screw slots.

Hood mounting screws (4)

13 15/16" (30" Hood)

16 15/16" (36" Hood)

Cabinet front

12 9/16"

Cabinet Bottom

5 1/4"

Vertical duct

access hole

1 1/4"

Center

Wood shims (recessed

line

bottom cabinets only)

Outside top exhaust

(Vertical duct–7" Round)

Use the diagram or the hood as a template and

mark the locations on the cabinet for ductwork,

electrical wiring and keyhole screw slots.

Hood mounting screws (4)

13 15/16" (30" Hood)

16 15/16" (36" Hood)

Cabinet front

Cabinet Bottom

Access

8" DIA.

hole for 7"

HOLE

round duct

Center

Wood shims (recessed

line

bottom cabinets only)

10 1/2"

1 1/4"

Electrical access hole

(in cabinet bottom)

12 1/2"

10 1/2"

2 1/4"

1 1/2"

Electrical access hole

(in cabinet bottom)