Atlantic Ultraviolet Nutripure 5B-SC 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Atlantic Ultraviolet Nutripure 5B-SC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Ultraviolet Nutripure 5B-SC 16 페이지. Sanitary conditioners

페이지 인쇄
Atlantic Ultraviolet Nutripure 5B-SC 소유자 매뉴얼
i
f
ntake
ilter
The Nutripure
Sanitary Conditioners are fitted with a Promate
®
•
DO NOT apply oil, or adhesive sprays to the filter(s).
In most applications, regular vacuuming will maintain peak performance of the Promate
•
flushing electrostatic filter(s) with clean water is recommended whenever vacuuming fails to restore a clean appearance.
•
Promate
Electrostatic Filter(s) may be cleaned repeatedly without loss of efficiency. The frequency of cleaning will vary
TM
with the conditions surrounding each installation.
The Promate
•
absolute HEPA filter is not washable and must be replaced after one year of continuous operation.
TM
C
e
leaning of
leCtrostatiC
IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY
EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES.
Always disconnect power to the fixture before performing any service or maintenance.
Disconnect power to the Nutripure
1.
Remove access cover. (Removal of the Nutripure
2.
lamps and blower. DO NOT attempt to bypass or circumvent the interlock switch or its safety feature.)
3. Remove Promate
filter(s) from the housing, noting airflow direction. The label on the filter frame shows the direction of air
TM
flow through the filter.
4. Vacuum the upstream side first, and repeat on the discharge side. Skip to step 7.
DO NOT use a high velocity water stream to clean the filter. A high velocity stream may damage
the filter's internal fibers.
To wash Promate
5.
TM
filter(s), flush thoroughly with clean water, either by immersing or with a fine spray in the direction
opposite to the airflow. If the filter(s) is contaminated with heavy grease concentrations, wash filter(s) with a detergent
solution. NOTE: Follow all manufacturer's instructions and precautions for handling detergents. The filter(s) should be
rinsed thoroughly with clean water.
6. Shake off any excess water from Promate
Replace Promate
7.
filter(s) into the housing, with airflow direction label pointing into the electrical enclosure.
TM
8. Reinstall access cover.
9. Plug Nutripure
®
into the electrical outlet to restore power.
10. Verify operation by viewing lamp(s) through Promate
"Troubleshooting" section
B
reakage
Broken Quartz is SHARP.
Wear protective gloves when handling broken ultraviolet lamp(s). In the event of breakage, DO NOT use a
household vacuum cleaner to pick up quartz fragments. Sweep up debris into a plastic bag and dispose of properly
D
m
isPosal of
erCury
Germicidal ultraviolet lamps, like standard fluorescent lamps contain small amounts of mercury. Mercury added
lamps should not be placed in the trash. Dispose of properly. For further information regarding the disposal and
recycling of lamps containing mercury, along with Federal and State requirements visit LampRecycle.org. For more
information on STER-L-RAY
f
ilter
®
and unplug from the electrical outlet.
®
access cover will cause the interlock switch to interrupt power to the
filter(s) and let dry.
TM
a
l
DDeD
amPs
®
Germicidal Ultraviolet Lamps, visit Ultraviolet.com or BuyUltraviolet.com.
TM
permanent, washable, electrostatic air filter(s).
sight glass. If the Nutripure
TM
TM
Electrostatic Filter(s); periodically
®
is not operating properly, go to
.
9