Electrolux RH30WC60GSB 사용 및 관리 매뉴얼 - 페이지 5

{카테고리_이름} Electrolux RH30WC60GSB에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux RH30WC60GSB 44 페이지. 30" and 36" free-standing range hood

페이지 인쇄

1. Lights

Important safety Instructions - Electrical & Installation

requirements

READ AND SAVE THESE INSTRUCTIONS

Electrical & Installation requirements

Electrical requirements

IMPORTANT

Observe all governing codes and ordinances.

Before installing the hood

For the most effcient air flow exhaust, use a

straight run or as few elbows as possible.

It is the customer's responsibility:

To contact a quali!ed electrical installer.

To assure that the electrical installation is adequate

and in conformance with National Electrical Code,

ANSI/NFPA 70 -- latest edition*, or CSA Standards

C22.1-94, Canadian Electrical Code, Part 1 and

C22.2 No.0-M91 - latest edition** and all local codes

and ordinances.

If codes permit and a separate ground wire is used, it

is recommended that a quali!ed electrician determine

that the ground path is adequate.

Do not ground to a gas pipe.

Check with a quali!ed electrician if you are not sure

range hood is properly grounded.

Do not have a fuse in the neutral or ground circuit.

IMPORTANT

Save Installation Instructions for electrical inspector's

use.

The range hood must be connected with copper wire

only.

The range hood should be connected directly to the

fused disconnect (Or circuit breaker) box through

metal electrical conduit.

Wire sizes must conform to the requirements of the

National Electrical Code ANSI/NFPA 70 -- latest

edition*,or CSA Standards C22.1-94, Canadian

Electrical Code Part 1 and C22.2 No. 0-M91 - latest

edition**and all local codes and ordinances.

Vent unit to outside of building and recirculating.

At least two people are necessary for installation.

The hood is fitted with Screws and Drywall

Anchors suitable for most surfaces, consult a

Qualified Installer, check if they perfectly fit with

your cabinet/wall.

Do not use flex ducting.

COLD WEATHER installations should have an

additional backdraft damper that is already

installed to minimize backward cold air flow and a

nonmetallic thermal break to minimize

conduction of outside temperatures as part

of the ductwork. The damper should be