Electrolux WRH608I Series 운영 매뉴얼 및 설치 매뉴얼 - 페이지 3
{카테고리_이름} Electrolux WRH608I Series에 대한 운영 매뉴얼 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux WRH608I Series 12 페이지. Retractable
Electrolux WRH608I Series에 대해서도 마찬가지입니다: 사용 설명서/설치 지침 (12 페이지), 사용자 설명서 (12 페이지)
페이지 인쇄
INSTALLATION INSTRUCTIONS
Please read instructions carefully. Service calls resulting from incorrect installation will be charged for.
Exhaust air from the cooker hood must not be discharged into any heating flue which may carry
combustion products from other sources. In addition, exhaust air must not be discharged into a wall
cavity, unless the cavity is designed for the purpose. Adequate ventilation of the room must
be ensured when the cooker hood is operating simultaneously with appliances burning gas or
other fuels. Installation must comply in all respects with your gas and electrical authorities. This
cooker hood is an indoor domestic appliance, and has been manufactured and tested to comply
with Australian and New Zealand Standard AS/NZS 60335.2.31
It is recommended th
at the unit be positioned at a mininum of 600mm from an electric cooktop
and 650mm for a gas cooktop, and no further from the cooktop than 800mm. Then unit
becomes less effective as the distance from the cooking surface to the hood increase.
FIXING POINT DIMENSIONS - 600mm Retractable cooker hood
FIXING POINT DIMENSIONS - 900mm Retractable
cooker hood
The maximum space between the wall and screw cap is 5mm.
Warning: Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards.
13427_Rangehood_Electrolux.indd
OPERATION GUIDE & INSTALLATION INSTRUCTIONS
3
650
DUCTING INSTALLATION
When installing with ducting pipe the Duct
spigot must be fitted to the ducting hole
on top of the body of the cooker hood
Duct Spigot
RECIRCULATING INSTALLATION
(For Models: WRH608I* WRR614*A & WRH908I*)
When installed in recirculating mode the
ducting hole cover must be fitted
Ducting hole
cover
600
P2