Atlas Copco AME 600 안전 및 작동 지침 매뉴얼 - 페이지 13

{카테고리_이름} Atlas Copco AME 600에 대한 안전 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco AME 600 20 페이지. Poker vibrators

AME 600

1. Remove cover (B), extract carbon brush (A) with

the help of a small screwdriver and disconnect

the connectors (C).

Note: Keep the connectors outside of the unit.

2. Insert carbon brush (A) in its housing in

accordance with its correct installation direction,

connect the connectors (C) and push the carbon

brush (A) to the stop in its housing.

3. Check the good condition of the O-ring (D)

4. Position the cover (B) with the pin upwards,

making sure the O-ring (D) is not damaged or

pinched. Tighten the cover (B) on the drive unit.

5. Repeat the procedure to replace the second

carbon brush (A).

Original instructions

Safety and operating instructions

NOTICE

If the carbon brushes are incorrect

positioned the commutator can be destroyed and, or

the casting may melt due to overheating. Sparks and

bad contact can occur if the contact between the

commutator and the carbon brush is to narrow and

sharp.

AT vibrator tube

Due to workload, ambient temperature and vibrations

caused by the vibrator poker's contact with the

concrete and/or rebar. This will cause wear on the

bearings and sealing and these will eventually fail.

When components have failed they must be replaced

with original parts. Replacement bearing kits are

available, see Spare part list.