Atlas Copco ETV ST101-270-20 제품 지침 - 페이지 10

{카테고리_이름} Atlas Copco ETV ST101-270-20에 대한 제품 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco ETV ST101-270-20 20 페이지.

페이지 인쇄

Operation

Ergonomic guidelines

Consider your workstation as you read through this list of general ergonomic guidelines and see if you can

identify areas for improvement in posture, component placement, or work environment.

■

Take frequent breaks and change work positions frequently.

■

Adapt the workstation area to your needs and the work task.

■

Adjust for convenient reach range by determining where parts or tools should be located to avoid

static load.

■

Use workstation equipment such as tables and chairs appropriate for the work task.

■

Avoid work positions above shoulder level or with static holding during assembly operations.

■

When working above shoulder level, reduce the load on the static muscles by reducing the weight

of the tool, using for example torque arms, hose reels or weight balancers. You can also reduce

the load on the static muscles by holding the tool close to the body.

■

Make sure to take frequent breaks.

■

Avoid extreme arm or wrist postures, particularly for operations requiring a degree of force.

■

Adjust for convenient field of vision by minimizing movement of the eyes and head during the work

task.

■

Use the appropriate lighting for the work task.

■

Select the appropriate tool for the work task.

■

Use ear protection equipment in noisy environments.

■

Use high-quality inserted tools or consumables to minimize exposure to excessive levels of vibration.

■

Minimize exposure to reaction forces.

■

When cutting:

A cut-off wheel can get stuck if the wheel is either bent or if it is not guided properly. Make sure to

use the correct flanges for cut-off wheels and avoid bending the wheel during cut-off operation.

■

When drilling:

The drill might stall when the drill bit breaks through. Makes sure you use support handles if the

stall torque is too high. The safety standard ISO11148 part 3 recommends using something to ab-

sorb the reaction torque above 10 Nm for pistol grip tools and 4 Nm for straight tools.

■

When using direct-driven screw or nutrunners:

Reaction forces depend on tool setting and joint characteristics. The ability to bear reaction forces

depends on the operator's strength and posture. Adapt the torque setting to the operator's strength

and posture and use a torque arm or reaction bar if the torque is too high.

■

Use dust extraction system or mouth protection mask in dusty environments.

Operating instructions

Operating

Make sure that the tool is in correct working order and that the controller is correctly programmed to avoid

unexpected behaviour from the tool, which may result in operator injury.

Check that the tool is in the correct running direction by looking at the function light situated above the tool

handle, by turning the reverse ring (only for ETV/ETD DS or by turning the arm on the trigger knob (only

for ETP DS).

The soft-start function facilitates entering the screw head and thread.

The duration of the soft start is adjustable, see the manual for the drive unit.

The tool is equipped with signal lights,

■

Green = OK tightening

ETV ST101-270-20