Atlas Copco ETV ST101-270-20 제품 지침 - 페이지 9

{카테고리_이름} Atlas Copco ETV ST101-270-20에 대한 제품 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco ETV ST101-270-20 20 페이지.

ETV ST101-270-20

Fitting of the tool cable

■

Make sure that the tool cable is of correct type.

■

Align the cable connector using the two asymmetrically positioned heads on the connector to fit in the

slots in the tool handle.

■

Tighten the lock nut.

■

Make sure that the connection is correct by pulling, pushing and turning the cable connector (there

should be no movement).

The tool has a built in electronic memory chip that will transmit the torque transducer calibration value

and angle pulses to the POWER FOCUS/drive unit. Any changes made of these values in the

POWER FOCUS while the tool is connected will be stored in the tool memory.

To clamp the tool to a fixture, only the areas marked grey on the figure can be used. However, be careful

not to damage the rubber coating when clamping the rubber handle.

NOTICE The white areas in the picture must not be used for fixturing.

Installation