Bose PANARAY 620M 서비스 매뉴얼 - 페이지 14

{카테고리_이름} Bose PANARAY 620M에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose PANARAY 620M 21 페이지. Multi-position floor array
Bose PANARAY 620M에 대해서도 마찬가지입니다: 설치 매뉴얼 (4 페이지)

페이지 인쇄

DISASSEMBLY PROCEDURES

Panaray Model 620M

Loudspeaker

Refer to figure at right for the

following procedures.

1. Grille Removal

1.1 Remove the four screws (11)

using a Phillips-head screwdriver.

1.2 Lift off the grille (1).

2. Handle Removal

2.1 Perform procedure 1.

2.2 Remove the two screws (13).

Lift off the handle (3).

3. Woofer Removal

3.1 Perform procedure 1.

3.2 Remove the four screws (12).

3.3 Lift out the woofer (2) and

disconnect the wires from the

terminals.

Re-assembly Notes: Be sure to observe

polarity when connecting the new woofer to

the wiring harness.

4. Tweeter Driver Removal

4.1 Perform procedure 1.

4.2 Remove the four screws (14).

4.3 Lift out the driver (5) and disconnect the

wires from the terminals.

Re-assembly Notes: Be sure to observe

polarity when connecting the new driver to

the wiring harness.

5. Neutrik

Speakon

5.1 Remove the two screws (15) for the jack

you wish to remove.

5.2 Lift off the input jack (10). Cut the wires

as close to the jack as possible. Refer to the

wiring diagram in the back of this manual

when installing the new jack.

6. Crossover Assembly Removal

6.1 Perform procedure 3.

6.2 Disconnect the crossover harnesses

from the woofer, tweeters and input jacks.

6.3 Remove the four nuts that secure

the crossover assembly (7) to the input

panel (9). Lift out the crossover assembly.

Jack Removal