Atlas Copco PBE 6 S 수리 지침 - 페이지 10
{카테고리_이름} Atlas Copco PBE 6 S에 대한 수리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco PBE 6 S 11 페이지.
페이지 인쇄
1
Mounting the
Push the insulating disk (5) and the
armature
ring (7) over the armature shaft and press
on the armature bearings (4) and (8).
2
Push the bearing sleeve (3) over the ar-
mature bearing (4).
3
Lightly grease the armature bearing (8)
and insert the complete armature into the
machine by turning it.
4
Insert the brush holders (C) into the motor
housing (9). Align them with the adjust-
ment tool (service tool) and fix them with
the screws (B).
5
Push the field (1) into the motor hous-
ing (9) and insert the air deflector ring (2).
Mind the right position!
6
Push the motor housing (9) with the
field (1) and the air deflector ring (2) over
the armature.
7
Fasten the motor housing with two short
screws (A) and two long screws (D).
1
Assembling the
Insert the switch (9) with the capacitor into
handgrip
the handle shell (7).
2
Insert the connecting cable (H) with the
cable entry sleeve as well as the cable
clamps (D) into the handle shell (7).
3
Fit the handle shell (C) with the holding-
down device to the other handle shell and
fasten them with the four screws (6).
4
Insert the handgrip holder (4) and the rub-
ber collar (3) into the handle shell (7).
5
Connect according to wiring diagram.
6
Insert the damping element (2) into the
housing.
7
Push the completed pair of handle shells
over the housing (F) and fasten it with the
screws (G).
8
Fasten both Torx screws (8) TX 30 of the
handgrip holder (4) together with the
disks.
9
Insert the handle cover (A) from above
and fasten it with the screw (B).
10
Screw down the handle screw (E),steady-
ing the knurled nut (5) at the same time.
Take care that no cables are jammed
or squeezed.
Repair Instructions No.182.03/98
h
i
j
k
7
6
5
4
3
e
2
1
PBE 6 S
8
7
6
5
4
3
C
2
1
D
C
A
B
8
9
b
e
a
D
a
b
H
j
k
G
PAGE
9
6
9
A
B
C
7
E
F