Atlas Copco PHE 6 S 수리 지침 - 페이지 4
{카테고리_이름} Atlas Copco PHE 6 S에 대한 수리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco PHE 6 S 18 페이지.
페이지 인쇄1
Detaching the
Loosen the two short (A) and the two
armature
long (D) screws.
2
Remove the motor housing (9) with the
field (1) and the air deflector ring (2).
3
Remove the air deflector ring (2) from the
motor housing (9) and expel the field (1)
from the motor housing (9).
4
Loosen the screws (B). Remove the brush
holders (C) from the motor housing (9).
5
Pull out the complete armature by turning
it. If necessary, hit the motor housing light-
ly with a plastic hammer for support.
6
Remove the bearing sleeve (3) from the
armature bearing (4).
7
Press off the armature bearings (4)
and (8) with aid of the forcing disks
(service tool).
8
Remove the insulating disk (5) and the
ring (7).
1
PHE 6 S:
Loosen both screws (6) and remove the
Detaching the
back part of the plastic housing (7).
spindle sleeve
2
Remove the plastic housing (8).
3
Fix the machine in a vice provided with
protective chops and remove the nose-
piece (1) (SW 50).
4
Press the rotary shaft seal (2) from the
nosepiece (1).
5
Remove the complete spindle sleeve (5)
from the housing. If necessary, hit the
housing lightly with a plastic hammer to
loosen the drill spindle.
6
Remove the spring ring (3) and press off
the bearing (4).
Attention! The nosepiece (1) has a left-
handed thread!
Repair Instructions No.181.03/98
h
i
j
k
1
2
5
PHE 6 H / PHE 6 S
8
7
6
5
4
3
C
2
1
D
C
5
3
4
8
PAGE
3
5
9
A
B
6
7
6