Atlas Copco 4390152285 제품 지침 - 페이지 6

{카테고리_이름} Atlas Copco 4390152285에 대한 제품 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco 4390152285 16 페이지. Torque arm

Installation

The tool torque should not exceed the specified torque range of each spe-

cific arm.

Do not use SMC 200 and SMC 300 with a bench stand.

Mounting on a bench

• Find the optimal position for the operator to handle the torque arm.

• Install the torque arm straight in front of the operator or alternatively to the

left or right depending on whether the operator is left or right-handed.

• Firmly tighten the screws in the holder that connects the torque arm to the

bench stand. The bench stand is pre-drilled for fixing to a bench.

• Attach the safety wire (see Spare Parts) to a second point that does not limit

the working area.

Mounting on a ceiling

• Put the mounting point straight above, or as close as possible to, the point

where the torque is applied.

• Make sure that the fixation point can handle the weight and the torque of the

chosen torque arm.

• Attach the safety wire (see Spare Parts) to a second point that does not limit

the working area.

SMC-100-1600