Atlas Copco P2550 제품 지침 - 페이지 8

{카테고리_이름} Atlas Copco P2550에 대한 제품 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco P2550 12 페이지.

페이지 인쇄

Service

Maintenance instructions

Overhaul and lubrication

If the tool is normally used as a heavy-duty tool it should be dismantled, over-

hauled and cleaned after 120 hours in operation. If the tool is not operating cor-

rectly, it should be taken out of service for inspection. Use lubricants of good

quality. The air motor oils and greases mentioned in the grease guide are exam-

ples of lubricants which are recommended.

At the overhaul, do the following:

• Inspect all disassembled parts for wear.

• Replace the cylinder ball and all the o-rings.

• Clean the dismantled parts with highly refined paraffin.

• Lubricate sliding parts before assembly.

NOTICE Risk of Cylinder Ball Damage

A metallic cylinder ball will damage the cylinder valve seat and piston valve

pin.

Do not replace the plastic cylinder ball with a metallic version.

►

Lubrication instructions

Rust protection and cleaning

Water in the compressed air can cause rust. To prevent rust we strongly recom-

mend to install an air dryer.

Water and particles can cause sticking of vanes and valves. This can be pre-

vented by installing an air filter close to the product to avoid pressure drop.

Before longer standstills always protect your tool by adding a few drops of oil

into the air inlet. Run the tool for 5–10 seconds and absorb any access oil at the

air outlet in a cloth.

NOTICE Do not try to clear the air path using sharp tools.

The air inlet is equipped with a strainer. If this is punctured, foreign objects

may harm the valves, resulting in overspeed.

Lubricating guide

Use lubricants of good quality. The oils and greases listed in the lubrication ta-

ble are examples of lubricants that can be recommended.

Brand

Castrol

Esso

Mobil

Shell

Texaco

General purpose

Bearings

Energrease LS-EP2

Spheerol EP L2

Beacon EP2

Rembrandt EP2

Mobilegrease XHP 222

Alvania EP2

Multifak EP2

P2550