Atlas Copco P2550 Інструкція до продукту - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція до продукту для Інструменти Atlas Copco P2550. Atlas Copco P2550 12 сторінок.
Друкувати сторінку
Service
Service
Maintenance instructions
Overhaul and lubrication
If the tool is normally used as a heavy-duty tool it should be dismantled, over-
hauled and cleaned after 120 hours in operation. If the tool is not operating cor-
rectly, it should be taken out of service for inspection. Use lubricants of good
quality. The air motor oils and greases mentioned in the grease guide are exam-
ples of lubricants which are recommended.
At the overhaul, do the following:
• Inspect all disassembled parts for wear.
• Replace the cylinder ball and all the o-rings.
• Clean the dismantled parts with highly refined paraffin.
• Lubricate sliding parts before assembly.
NOTICE Risk of Cylinder Ball Damage
A metallic cylinder ball will damage the cylinder valve seat and piston valve
pin.
Do not replace the plastic cylinder ball with a metallic version.
►
Lubrication instructions
Rust protection and cleaning
Water in the compressed air can cause rust. To prevent rust we strongly recom-
mend to install an air dryer.
Water and particles can cause sticking of vanes and valves. This can be pre-
vented by installing an air filter close to the product to avoid pressure drop.
Before longer standstills always protect your tool by adding a few drops of oil
into the air inlet. Run the tool for 5–10 seconds and absorb any access oil at the
air outlet in a cloth.
NOTICE Do not try to clear the air path using sharp tools.
The air inlet is equipped with a strainer. If this is punctured, foreign objects
may harm the valves, resulting in overspeed.
Lubricating guide
Use lubricants of good quality. The oils and greases listed in the lubrication ta-
ble are examples of lubricants that can be recommended.
Brand
BP
Castrol
Esso
Q8
Mobil
Shell
Texaco
8
EN
General purpose
Bearings
Energrease LS-EP2
Spheerol EP L2
Beacon EP2
Rembrandt EP2
Mobilegrease XHP 222
Alvania EP2
Multifak EP2
© Atlas Copco Industrial Technique AB - 9839 0711 01
P2550